Wood Nc Sanding Sealer

Product Details:

Surfa Wood Rich is based on the chemistry of Acrylic and Nitro Cellulose lacquers.

The range of products includes:

1.  Surfa N C  Wood Filler

2. Surfa N C Sanding Sealer

3. Surfa N C Cabinet Clear

4. Surfa  1k Acrylic Clear

Products are recommended for use on wooden surfaces. Products are free from formaldehyde and lead.

METHOD OF APPLICATION:-

Surface Cleaning:-

For Pre-Polished Wood: Remove all existing coatings by sanding or scraping

For New Wood: Wooden surfaces to be sanded by using emery paper No.180 followed

                            by 320.

                            Clean the surface free of dust particles by wiping off.

If necessary, remove dust and grease using a cloth soaked in Surfa D13 N.C thinner or equivalent.

Under Coat:  To fill minor pores, apply Surfa N.C Wood filler using a putty knife or muslin cloth and remove excess coating. Sand the coat after 1 hour with emery paper No.240 and wipe clean.

To Seal the surface: Thin Surfa N.C Sanding Sealer with 100 parts of Surfa D13 N.C thinner for padding or 150 parts for spray. Permit 1 hour interval between successive coats. Use emery paper 240/320 to scrub leftover coats. Apply minimum 2 coats for better sealing.

Top Coat:

For Top coat, use one of the following products

Surfa 1K Acrylic Clear MATT/GLOSSYor Surfa  N C Cabinet Clear or Surfa Wood Shield- GLOSSY (PU based).

 Apply the products strictly as per following directions.

For Surfa 1K Acrylic Clear Matt on filled wood apply 3 coats of Matt. For Surfa 1K Acrylic Clear Glossy use 2 coats of Matt and 2 coats of Glossy. To dilute Surfa 1K Acrylic Clear use 40-50 parts of Surfa NC Thinner SP 58.

For Surfa N C Cabinet Clear Glossy/Matt thin with 50 parts of Surfa N C Thinner SP50. Apply minimum 2 coats by spray for better result. Further coats can be applied, if more gloss is required. Allow minimum 2 hours interval between successive coats. Use emery paper No 400/600 between coats.

For Surfa Wood Shield Interior Glossy( PU Based) : Thin with for brushing add 10% of Thinner  14 or Enamel Thinner 600 and mix well. For spraying add 20% of Thinner 14 or Enamel Thinner 600 and mix well. Apply 2 coats of thinned Wood Shield Interior Glossy by brush or spray allowing 12 hours drying time between coats.